Hello,
I've successfully upgraded the ram of my WL-500G Premium to 128Mb by following Oleg's instructions. The very last operations were:
Then I've run "memtester 64M" for about 3 loops. There was no problem. In the end, I stopped memtester with ctrl-c and powered off the device.
About 1 or 2 hours later, I came back and powered on the device, but the power led never turned on:
What could have happened, and how could I repair the device?
My OS: OpenWRT 10.03
TIA for any help!
Peter
I've successfully upgraded the ram of my WL-500G Premium to 128Mb by following Oleg's instructions. The very last operations were:
Code:
nvram set sdram_init=0x0011
nvram set sdram_config=0x0062
nvram set sdram_ncdl=0
nvram commit
rebootAbout 1 or 2 hours later, I came back and powered on the device, but the power led never turned on:
- no more power led
- no network (no ping response on 192.168.1.1)
- no recovery (restore button on power up)
- no messages on UART_TX0 and UART_TX1
What could have happened, and how could I repair the device?
My OS: OpenWRT 10.03
TIA for any help!
Peter